Dell Wireless Printer Setup

Dell Wireless Printer Adapter 3300

Dell Wireless Printer

Configuration :

1. Connect the large end of the USB cable to your computer USB port.
2. Insert the small end of the USB cable into the left side USB port of the wireless printer adapter.
3. Connect the wireless printer adapter to its power supply.

4. Insert the Dell Wireless Printer Adapter 3300 Setup CD in the CD drive.
   The Setup Wizard on the Setup CD will automatically launch.
5. Click Agree on the License Agreement screen.
6. Select the destination folder for the Dell software, and then click the Finish button.
7. After the software has installed, click the Next button on the Welcome screen.
8. Select the appropriate Network Name (SSID) from the list, and then click next.

1. Select I want to enter a different configuration, and then click Next.
2. If the correct Network Name is still not in the list, make sure that your wireless network is functioning, and try again.
3. If your wireless network is broadcasting and the correct Network Name still does not appear, from the Wireless Networks Found in Your Area screen, select I want to enter a different network name, and then click Next.

9. Enter the Network Name (SSID) of the network that you want to use. If you're not sure which network you want to use, refer to your network documentation or check with your network administrator.
10. Select the appropriate channel for the network.

11. Select Access an existing network through a wireless router (Infrastructure Mode) - Typical.
12. Click the Next button.
13. Select the appropriate security method, and then click Next.
14. If no security was detected, go to step 16.
15. Enter the appropriate security key(s) for your network, and then click Next.
16. Check each network attribute on the summary screen to make sure that the settings are correct. If the settings are correct, click Next to apply these settings to your wireless printer adapter.
17. Disconnect the USB cable from both your computer and the wireless printer adapter.
18. Continue with Connecting your wireless printer adapter to your printer.

1. Using the same cable to connect the wireless printer adapter to your printer, insert the large end of the USB cable into the middle USB port on the back of the wireless printer adapter, and then insert the small end of the USB cable into your printer.

1. Click the Next button to continue with the Setup Wizard on the Setup CD.
2. Write down the port or MAC address information displayed on the screen

4. Click the Finish button to close the Setup Wizard on the Setup CD.
5. Remove the Setup CD from your computer, and insert your printer software CD.
6. Continue with Installing your printer on the network.